The Map view of system layout proposes the plan view of the location
where the system is sited. The program can work in two map mode:
Dynamic map mode
Static map mode
Dynamic map mode: this mode
is possible only with the internet connection, dynamically getting
images of the site map.
Static map mode: in this
mode the program stores a static image, read by internet, of the
site. This image has a limited extension but after being read can
also be shown without the active internet connection.
When running the Wizard design, the map display mode is always
dynamic and can not be changed by the user, so it requires access to
the Internet. When the wizard ends, a sufficiently extensive image is
generated to fit the photovoltaic plant area and the program is set
to work in static mode.
In this way the user can continue to work on the project even without
an internet connection. But also out of the wizard the user can swap
the static and dynamic mode, or change the image of the static mode.
In the lower left of the layout area, you will found a menu that
allow to modify the map mode.